05-17-2013, 10:44 AM
Here is another hobby project:
[ATTACHMENT NOT FOUND]
A ROWI vintage ballhead bolted to a solid steel disk. It provides me with a very low (9cm), yet stable (over 1.5 kg, bottom covered with rubber) support for my camera.
On top I put an aluminium part to enable paralax-free horizontal stitching, and glued part of a plastic ruler to note the distances for the different lenses. Now all I need to make is an aluminium L-plate.
[ATTACHMENT NOT FOUND]
A ROWI vintage ballhead bolted to a solid steel disk. It provides me with a very low (9cm), yet stable (over 1.5 kg, bottom covered with rubber) support for my camera.
On top I put an aluminium part to enable paralax-free horizontal stitching, and glued part of a plastic ruler to note the distances for the different lenses. Now all I need to make is an aluminium L-plate.