• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Forums > Back > Holding all the bits in place….
soLong
Unregistered
 
#1
03-17-2015, 09:57 PM
….Sorry, as an opener if these words are senseless, but I’ve noticed that whenever I buy a new lens or receive one back from service the VR is always left switched on….Well I never use VR, but should I guess that turning it on actually holds the lens parts more securely in place for transport or un-use, or positions the elements correctly first up….ie: switch it off for shooting and on for un-use (in my old fashioned case :-) ….or is this another wrong guess and just a coincidence.

  Reply


Messages In This Thread
Holding all the bits in place…. - by soLong - 03-17-2015, 09:57 PM
Holding all the bits in place…. - by JJ_SO - 03-18-2015, 06:13 AM
Holding all the bits in place…. - by soLong - 03-19-2015, 02:04 AM
Holding all the bits in place…. - by Scythels - 03-19-2015, 04:32 AM
Holding all the bits in place…. - by JJ_SO - 03-19-2015, 06:20 AM
Holding all the bits in place…. - by Scythels - 03-19-2015, 06:39 PM
Holding all the bits in place…. - by davidmanze - 03-19-2015, 06:40 PM
Holding all the bits in place…. - by JJ_SO - 03-19-2015, 09:09 PM
Holding all the bits in place…. - by Scythels - 03-20-2015, 12:31 AM
Holding all the bits in place…. - by JJ_SO - 03-20-2015, 08:32 AM
Holding all the bits in place…. - by Scythels - 03-20-2015, 05:35 PM
Holding all the bits in place…. - by JJ_SO - 03-20-2015, 07:07 PM
Holding all the bits in place…. - by Scythels - 03-20-2015, 10:57 PM
Holding all the bits in place…. - by popo - 03-20-2015, 11:50 PM
Holding all the bits in place…. - by Scythels - 03-21-2015, 05:36 AM
Holding all the bits in place…. - by JJ_SO - 03-23-2015, 05:56 AM
Holding all the bits in place…. - by Scythels - 03-23-2015, 04:18 PM
Holding all the bits in place…. - by Scythels - 03-23-2015, 05:53 PM
Holding all the bits in place…. - by Scythels - 03-23-2015, 07:35 PM
Holding all the bits in place…. - by Scythels - 03-24-2015, 01:18 AM

Forum Jump:


Users browsing this thread: 3 Guest(s)