Opticallimits > Forums > Just Talk > Holding all the bits in place….
Opticallimits > Forums > Just Talk > Holding all the bits in place….

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Holding all the bits in place….
Scythels
Unregistered
 
#21
03-23-2015, 07:35 PM
It was C mount from the film era.  based on the manufacturing documents I used to reconstruct it the spec was for about a 52 degree FoV (16mm film).  Super 16 would be something like 54-58 degrees based on my estimate and ultra 16 would be slightly more - maybe 60 degrees.  The lens isn't too too heavily vignetted (1-1.5 stops or so) so it would probably do okay on those formats as well.

Reply
  


Messages In This Thread
Holding all the bits in place…. - by soLong - 03-17-2015, 09:57 PM
Holding all the bits in place…. - by JJ_SO - 03-18-2015, 06:13 AM
Holding all the bits in place…. - by soLong - 03-19-2015, 02:04 AM
Holding all the bits in place…. - by Scythels - 03-19-2015, 04:32 AM
Holding all the bits in place…. - by JJ_SO - 03-19-2015, 06:20 AM
Holding all the bits in place…. - by Scythels - 03-19-2015, 06:39 PM
Holding all the bits in place…. - by davidmanze - 03-19-2015, 06:40 PM
Holding all the bits in place…. - by JJ_SO - 03-19-2015, 09:09 PM
Holding all the bits in place…. - by Scythels - 03-20-2015, 12:31 AM
Holding all the bits in place…. - by JJ_SO - 03-20-2015, 08:32 AM
Holding all the bits in place…. - by Scythels - 03-20-2015, 05:35 PM
Holding all the bits in place…. - by JJ_SO - 03-20-2015, 07:07 PM
Holding all the bits in place…. - by Scythels - 03-20-2015, 10:57 PM
Holding all the bits in place…. - by popo - 03-20-2015, 11:50 PM
Holding all the bits in place…. - by Scythels - 03-21-2015, 05:36 AM
Holding all the bits in place…. - by JJ_SO - 03-23-2015, 05:56 AM
Holding all the bits in place…. - by Scythels - 03-23-2015, 04:18 PM
Holding all the bits in place…. - by Scythels - 03-23-2015, 05:53 PM
Holding all the bits in place…. - by Scythels - 03-23-2015, 07:35 PM
Holding all the bits in place…. - by Scythels - 03-24-2015, 01:18 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)